Page 12 of 14
4
Adjusting the Flame Height
To lower the flame height press and hold the DOWN BUTTON until the flame is at
the desired height. To turn the main burner off and just leave the pilot burner alight
continue to press and hold the down button until the main burner does out. To re-
light the main burner press and hold the SMALL BUTTON and UP BUTTON together
until the flame is at the desired height.
5
Turning the Fire OFF
To turn the fire off but leave the pilot burner alight press the DOWN BUTTON until
the main burner does out. To turn the fire completely off press the OFF button.
Manual Off Facility
If, whilst the fire is alight, the handset control is lost or its battery becomes
discharged the fire can be turned off by switching the appliance ON/OFF switch
(located just behind the signal receiver which is situated just in front of the right
hand side of the main burner) to the OFF position which is indicated by the symbol
O
. Caution should be exercised as this switch is situated quite close to the pilot
flame. Switch back to the ON position to allow the appliance to be re-lit when
required.
Cleaning the fire
1
Ensure that the fire is cold before undertaking any cleaning. Remember that heat is
retained for some time after the fire is switched off. In normal use your fire requires
only minimal cleaning. Some soot may form on any ceramic pieces placed in the
flames but this is generally harmless unless an excessive amount is deposited.
2
If large pieces of debris are found in the fire, sufficient to alter the appearance or
operation of the appliance, the chimney / flue should be inspected and the
appliance serviced before further use.
In any event, the chimney should be checked annually to ensure continued clearance of the
combustion products and that there is no excessive build-up of soot.
