Verilink Wansuite 5230, Справочное руководство

Страница: 165 / 233

V T 1 0 0 I n t e r f a c e 4-49
can see if any port is under test, and if so, view the results. You may change
Diagnostic parameters on the Test Details screen (Figure 4.42), which is
accessed by selecting the appropriate interface under the <Description>
column. The properties of the Diagnostics table are described in the
paragraphs below.
Figure 4.41 Diagnostics Screen
Description Describes the type of interface selected for testing.
Loop Type Describes the type of loop test (if any) performed on the selected interface.
Setting Displays the bandwidth on which you wish to perform the BERT.
Pattern Specifies the pattern to be transmitted during a BERT for the selected port.
Length Displays the length of time for which the BERT should run for the selected
interface.
State Displays the current BERT state for the selected interface.
Test Details Screens
The Test Details screens let you set some test parameters and view other read-
only parameters. This screen is also used to initiate a BERT or Loop Test. The
Network Interface Test Details screen is shown in Figure 4.42, and its
parameters are described below the figure. The Serial Interface Test Details
screen is shown in Figure 4.43, followed by a description of its parameters.