Operation, Maintenance & Safety Manual
Version 7.01 January 2006
7
2.5
Operational Safety
•
Always isolate the power supply before working on the pump!
•
Never place hands or other parts of the body inside or near any part of the pump when it is in
operation or when the power is not totally isolated!
•
Maintain a clean environment around the pump. The VERDERFLEX
®
Dura
®
pump is
manufactured from cast steel, and therefore the flanges and Housings etc may have sharp
edges - slipping or falling against the pump may cause serious injury.
•
When the pump is running, you should not touch the pump and should maintain an adequate
safe distance around it!
•
Do not climb onto the pump or connecting pipe work.
Wear safety clothing (glasses, hats, gloves, boots, etc) when operating or working on the pump or in
its immediate vicinity.
2.6
Maintenance Safety
•
Always isolate the power supply before working on the pump!
•
Always follow the safety procedures for handling the product being pumped! (Refer to MSDS)
•
If the hose has ruptured, the lubricant may be contaminated with product, care must be taken to
handle the mixture appropriately.
•
Do not stand near the pump while the hose is being removed, if the hose is expelled too quickly,
it could cause serious injury.
•
Never try to install a hose without the front cover in place.
•
Never remove the front cover when the hose is still in position.
•
When removing the front cover, suitable lifting equipment may be required to support the weight.
Always use lifting equipment safely in accordance with the manufacturer’s recommendations.
The pump is provided with a lifting eye should the need to move the pump arise.
•
Do not stand in the immediate vicinity of the pump when operating with the inspection cover
removed, follow safety procedures for operation of pump with inspection cover off.
•
Extreme care must be taken when removing the rotor and shaft from the pump housing & drive.
Loads must be properly supported to prevent injury.
•
Do not strike the pump shaft, the inner race or the bearings.
•
Once installed, the bearings are greased for life; do not lubricate after installation.
