11
Reset
The desk may need to be reprogrammed / reset after any of the following:
After assembly; after disconnection from the power supply or after any impact on the
table top.
In the case of a reset becoming necessary downward movement of the table at a
reduced speed is possible. On handset models with display "Reset-LED" will be
indicated. This display clears once the initialization has been completed
successfully.
To reset you have to drive the table to the lowest position by holding the down
button of the hand switch pressed until all drives reach the lowest position. Then
press the down button again and hold it pressed (about 5 seconds) until a slight
movement of the table drops down to the machine zero point and back up to the
operation zero point and the table stops moving, after that release the button. If the
button is released too early, this leads to a malfunction at the table. If this occurs
you must repeat the process.
The upper end position is preset in the control unit. For this reason, only control
units that have been provided for each specific desk frame should be used. Under
no circumstance should a control box from one desk be moved to another.
Operation
Normal mode
(with all handset types)
With the Up and Down keys, move the table in the direction up or down, the table
stops when it reaches the end position. Depress the up or down button as required
until the desired position is reached.
Standard Handset
HDU Handset (optional)
