- 8
Veo Europe_VIPN-2xxx Observer Plus_UserManual rev1.0 EN
2. Installation
Before installing the Observer Plus, you should have an available Ethernet LAN
connection (RJ-
45 port). To view the camera’s image or make any manual
configuration changes, you will need a Windows PC with Internet Explorer 6.0 or
higher and connection to the LAN.
2-1. Observer Plus Hardware Setup (LAN Setup)
1.
Plug the Ethernet cable into Observer Plus
2.
Plug the Ethernet cable into PC or Router
3.
Connect the Power Supply to the Observer Plus
, Camera power LED ON
4. Wait 45 sec to 60 sec, the camera will auto Pan and Tilt, moving to camera
center
5. Use the IPEdit.exe tools to find the Observer Plus and setup camera IP address.
6. Use IE to view the Observer Plus image.
7. Connect to Router using Blue Cable when settings completed
Step 1. Plug the Ethernet cable into Observer
Plus
Plug the included RED Color Ethernet cable into the
RJ- 45 connector at the back of the camera as
shown.
Step 2. Plug the Ethernet cable into PC or Router
1.Temporarily disconnect the existing network cable
from the PC.
2.Plug the other end of the Ethernet cable into any
available LAN port. A typical home router /gateway
connection is shown on the left.
Step 3. Connect the Power Supply to the Observer
Plus
Connect the power supply to the back of the Observer
Plus as shown, and then plug the supply into an
available power outlet.
The Camera Power LED ON (Blue)
