Venturo ET12K, Руководство по установке

Страница: 25 / 52

SECTION DATE
SUPERSEDES
TITLE
ET6/8/10/12K(X)
C200
01-15-15G
12-26-13F
INSTALLATION DWG
900530A
CRANE OPERATION AND MAINTENANCE INSTRUCTIONS
SAFETY
Before operating this crane, read and understand these instructions, the 850711 Crane Safety
and Hazards Information Sheet, and review all safety and instruction labels on the crane.
CRANE INSPECTION
Before operating this crane, inspect for wear, damage, and oil leakage. After the wire rope has
been run out, check for wear, kinks, and broken strands. Check the hook and safety latch for
damage. Correct problems before using the crane.
CAPACITY
Before operating this crane, review the capacity charts on the sides of the boom to relate the load
to be lifted to the boom length and angle. The boom angle is indicated by a gravity arrow.
LOAD BLOCK
If the load exceeds:
1000 lbs. for the ET6K, or
1600 lbs. for the ET8K(X) and ET10K(X), or
1750 lbs. for the ET12K(X),
or if reduced winching speed for better control of smaller loads is required, use the load block to
rig the crane for two-part line operation. Refer to drawing 27423, 21701, 17450, or 21575,
respectively.
CONTROLS
This crane is operated by a remote control pendant. The pendant should be unplugged and
stored in a compartment or the cab when the crane is not in use.
Before plugging the pendant in, inspect the plug, socket, cord, oandant head, and switches for
damage. Actuate all four [4] switches both directions to verify that they all have the same feel and
sound, and that they return to the center position.
Plug the pendant into the socket on the right side of the crane and, if applicable, snap the strain
relief tether to the crane housing.
Turn on the Master Disconnect Switch. Use "WINCH DOWN" to release tension on the wire rope
and unhook it from the storage tie-down position.
Use "BOOM UP" to elevate the boom from the boom rest position.
Check all control functions to see that they are working correctly.
®
VENCO VENTURO INDUSTRIES LLC
CINCINNATI, OHIO