Vents VUE 180 P5 EC, Руководство пользователя

Страница: 12 / 20

12
www.ventilation-system.com
VUT/VUE 180 P5(B) (EC)
CONNECTION TO POWER MAINS
The air-handling unit is rated for connection to single-phase AC 220-240 V/50 (60) Hz power mains. The unit must be connected to power
mains using durable, insulated and heat-resistant conductors (cables and wires) with minimum cross section not less than 1 mm
2
.
The external power input must be equipped with an automatic circuit breaker built into the stationary wiring to open the circuit in the
event of overload or short-circuit. The position of the external automatic circuit breaker must ensure free access for quick power-off of
the unit. The circuit breaker trip current must correspond to the unit current consumption, refer to the Technical data section.
Connect the cables to the control unit using the electric lead-ins on the side of the unit.
Make the electric connections through the terminal block, located in the control unit, in compliance with the External wiring diagram.
Access to the control unit
DO NOT LAY THE POWER CABLE OF THE UNIT IN CLOSE PROXIMITY
AND PARALLEL TO THE CONTROL PANEL CABLE! DO NOT COIL THE
CONTROL PANEL CABLE WHILE LAYING ITS OUT.
External control units wiring diagram for units with an A14 control panel
2 3 4 14 13 12 11 10 9 8 7 6 5 15
L
1
External device
NO (CO
2
sensor)
PK fire alarm panel
(remove the jumper while
connecting the contact)
230 V/ 50(60) Hz
Control panel
- Tx Rx +
GND Tx Rx +U
3
2
1
GND
+U
0-10V
GND +U 0-10V NО N PE PК РК C
X1
16
SM-L
17
SM-N
Humidity
sensor
W
hit
e
Bro
wn
Gr
een
Yello
w
XP
QF
Electric actuators
of the external air dampers
SM1
supply
L1 N
SM2
exhaust
L1 N
Designation Name Model Wire**
NO
External control unit contacts
LF230 2 x 0.75 mm
2
SМ1*
Supply air damper actuator
LF230 2 x 0.75 mm
2
SМ2 *
Exhaust air damper actuator
LF230 2 x 0.75 mm 2
РК*
Contact from fire alarm panel
NO 2 x 0.75 mm 2
* Is not included in the delivery set.
** Maximum connecting cable length is 20 m!
DISCONNECT THE UNIT FROM POWER MAINS PRIOR TO ANY OPERATIONS.
THE UNIT MUST BE CONNECTED TO POWER SUPPLY BY A QUALIFIED ELECTRICIAN.
THE RATED ELECTRICAL PARAMETERS OF THE UNIT ARE GIVEN ON THE
MANUFACTURER’S LABEL.
ANY TAMPERING WITH THE INTERNAL CONNECTIONS IS PROHIBITED
AND WILL VOID THE WARRANTY.