6
If
you are adding
a
light
kit. Please install the light kit in the following steps:
6 . L I G H T C O N N E C T I O N ( O P T I O N A L ) :
LIGHTING DIAGRAM
FIBREGLASS
SLEEVE
ADAPTOR
STAR WASHER
BACK
PLATE
LAMP HOLDER
BRACKET
LAMP HOLDER
STAR
WASHER
NUT
GLASS
KNOB
Warning: All electrical
connections and disconnection
must be performed by a
Licensed electrician.
A/ Remove the decorative screw at the bottom of the motor, and pull the light kit
supply wires from the motor shaft. Fit fiberglass insulating sleeve over the light kit
supply wires.
B/ Insert the light kit supply wires through the adaptor, ensuring that the star washer
is to the back of the light kit plate, and screw the adaptor into the fan motor
shaft and secure.
C/ Secure the light kit onto the fan via the adaptor and then connect the wiring to
the terminal block located on the plate of the Light Kit.
WARNING: MAKE SURE "ACTIVE" TO "L", AND NEUTRAL TO "N" OF THE LUMINAIRE
TERMINAL BLOCK.
D/ Excess insulation sleeving should be fed back into the motor body.
E/ Install recommended light bulbs. Ensure wiring insulation is kept clear of the bulb.
7. WIRING INSTRUCTION – MOUNTING BRACKET TERMINAL & WALL CONTROL:
Carefully connect the wires using the wiring diagrams 8a) and 8b).
