INTRODUCTION
Commercial Single EC Fan Trickle/Boost Controller incorporating the following
functionality:
Controls trickle and boost speed for EC single fan.
Trickle and boost speed set by on-board potentiometers.
Live switch input for boost speed selection
SPECIFICATION
475775 EC Trickle/Boost Fan Controller
Supply Voltage
V AC
230 VAC
AC line Frequency
Hz
50 Hz
Supply Power
W
1W
Operating
Environment
-20 to 40°C, IP22 Enclosure
Dimensions
Enclosure 94mm(L) x 94mm (W) x 57mm (H)
Fixing Hole Centres
79 x 79mm
CONNECTION DETAILS
Switched Live Mains Connector J1
Pin Function
LS
Switched Live, boost speed select input
N
Neutral
Fan Motor Controls Connector J2
Pin Function
10V
10 Volts supply
0V
Ground
1/10V
0 to 10 Volts fan speed control output
INSTALLATION
See “Safety” information at the beginning of this document.
Wiring:
For connections; see connection details table above and wiring diagram below - Route
control wiring separately from AC mains wiring.
Remove enclosure knock-outs as required to fit cable glands, taking care not to damage the
PCB.
Ensure that the switch S1 on the control PCB of the EC Slimpak Single Fan unit is set to the
EX position, see wiring diagram below.
