IMPORTANT: READ THESE INSTRUCTIONS
BEFORE COMMENCING THE INSTALLATION
IMPORTANT SAFETY INFORMATION
1.
DO NOT install this product in areas where the following may be
present or occur:
2.
Excessive oil or a grease laden atmosphere.
3.
Corrosive or flammable gases, liquids or vapours.
4.
Subject to direct water spray from hoses.
5.
Ambient temperatures higher than 40°C or less than –20°C.
6.
Possible obstructions which would hinder the access or removal of the
Controller.
7.
All wiring must be in accordance with the current IEE wiring regulations
BS7671, or appropriate standards of your country. Installation should be
inspected and tested by a suitably qualified person after completion.
8.
Ensure the mains supply (voltage, frequency and phase) complies with
the rating label.
9.
A means for electrical disconnection must be incorporated in the fixed
wiring to the unit in accordance with the wiring rules having a contact
separation in all poles of at least
3mm.
10. Precautions must be taken to avoid the back-flow of gases into the
building from the open flue of gas or other fuel-burning appliances.
11. This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
12. Young children should be supervised to ensure that they do
not play with the appliance.
INSTALLATION GUIDANCE:
1.
The installer is responsible for the installation and electrical connection of the system on site.
It is the
responsibility of the installer to ensure that the equipment is safely and securely
installed and left only when mechanically and electrically safe.
2.
All regulations and requirements must be strictly followed to prevent hazards to life and
property, both during and after installation, and during any subsequent servicing and
maintenance.
3.
When removing enclosure knock-outs take care not to damage the controller PCB.
4.
All mains connections to the unit using flexible wiring or any additional controls wiring
must use cable glands sufficient to retain the IP rating of the unit and provide cable
retention to the requirements of EN60335-1 Clause 25.15.
5.
EC fans use capacitors to store mains voltage, contact with the mains wiring must be
avoided for 5 minutes following supply disconnection.
