venotec Abyzz A200, Руководство по эксплуатации

Страница: 27 / 40

!
Troubleshooting
If, despite the high standard of quality, faults should occur, please use the checklist
below to rectify or restrict the problem. A number of faults are already detected and
displayed by the electronics.
If you cannot rectify the fault by checking the lines (incorrect connections), mains
voltage, and pump (smooth running, blockages), please contact your specialist
dealer. In such cases, please be ready to state the serial number of the driver and
of the motor. The serial numbers are on the blue serial number sticker or on the
packaging.
Malfunction Cause Remedy
The display does not
light up and the LED
flashes
a) Screensaver on a) Press a button
The display does not
light up and the LED
does not flash
a) No mains voltage
b) Fuse or fuses faulty
a) Check the mains
connection
b) Replace the fuses
If the fault cannot be rectified
(e.g. if the fuses are
repeatedly faulty), there is a
driver fault. In this case,
please contact the service
team.
Status: COMM FU! a) Control unit communications
failed
a) Switch off the device and
switch back on after 10
seconds
Status: Imax! a) Overcurrent fault, motor
overloaded
a) Check motor to make sure
that it can move freely
Status: MOTOR? a) Motor not detected a) Check connection to
motor, check plug
Status: TEMP! a) Driver overheated a) Let the driver cool down,
lower the ambient
temperature
Status: DRYRUN! a) Motor has run dry or is
drawing in air
a) Check the water level,
check the pipes for leaks
Status: LOW VOLT! a) Mains voltage too low
b) Too many devices on one
lead
c) Mains lead too long
a) Check the mains voltage
b) Reduce the number of
devices
c) Reduce the length of the
lead, remove multi-socket
strips
Device is working but cannot
reach maximum power
! 27