venotec Abyzz A200, Руководство по эксплуатации

Страница: 16 / 40

!
The text displayed in the first line changes from "Stopped" to "Running" if you
increase the speed and switch on the pump:
If you are using an
ACS , the current address of the driver is displayed in the
overview (display of status page 15 below).
LED:
The LED flashes to show that the product is working properly.
Keyboard:
The keyboard enables the direct control of the pump and the programming of the
pump in the menu.
Operation
In the "Permanent" operating mode (set when delivered), you can use the start/
stop button to start or stop the motor. You can adjust the speed using the up and
down buttons. If you want to store the new speed permanently, press "M". The set
value is then retained by the system. The start/stop setting is stored automatically
so that the pump automatically starts in its previous operating mode following an
interruption in the operating voltage or if the mains switch is switched off.
If you want to enter the menu to view operating data or to program the pump,
press "M".
The menu appears and the current operating mode is displayed. Use the up and
down buttons to navigate in the menu. The software status, operating hours, and
operating mode are displayed one after the other.
! 16
Running at:30%
Temp:26C
Mode:Permanent
Speed:0rpm S
↕
Display of operating mode
Display of current speed
EN
G
LI
SH