7. REINSTALL GREASE FILTER
To reinstall the grease filter, align down filter tabs with slots in the hood. Press down the
metal latch tab, push filter into position and release. Make sure the filter is securely
engaged after installation. Close the hood front panel.
11. Drill both screw holes using a 5/16” drill bit through inner hood mounting holes. Insert
the included drywall anchors into the drilled holes (one per hole). Secure the hood
using 2 no. 8 x 1¼” screws with 2 washers.
6. INSTALL THE HOOD
(CONT’D)
HD0294
I
NNER
H
OOD
M
OUNTING
H
OLES
12. Restore electrical power at service panel.
HD0252
8. LIGHT BULBS
This range hood requires two UL approved halogen bulbs (JC type, 12 V, 20 W).
To replace bulbs:
1. Gently push the rim upward and rotate to disengage the light bulb cover.
2. Replace with JC type, 12V, 20 W Max, G-4 base halogen bulb.
3. Reinstall the light bulb cover by pushing the rim upward and rotating the light bulb
cover until secure.
WARNING
Make sure power is switched off at service panel before carrying out any
operation on the hood.
!
WARNING
In order to prevent the risk of personal injury, the halogen lamps must be
cooled down before removing them.
CAUTION
Do not touch replacement bulb with bare hands!
!
LIGHT BULB COVERS
HD0253
- 9 -
