- 8 -
1) Delay switch
3) Master OFF/Filter maintenance switch/Heat detector
2) Start/Stop/Speed selection switches
4) Light switch
1
2
3
4
1. Delay switch:
When a speed is selected, press the delay switch to activate the delay function.
The corresponding speed indicator light will start flashing to indicate this function
is activated. The fan will continue to operate for 5 minutes and will stop automatically.
To cancel the delay function, press the delay switch once again.
2. Start / Stop / Speed selection switches:
Press the switch corresponding to the desired fan speed. The light indicates the
selected speed (from speed“1” for Silentsure™* mode to for ’’Boost Mode’’).
To turn off the fan, press once more on the corresponding fan speed switch.
3. Master Off / Filter maintenance switch / Heat detector: (Triple function switch)
a) To turn Off the motor and the lights simultaneously, press the switch once.
b) After 25 hours of operation, the filter maintenance light indicator will turn
itself on. This indicates that the filters and the blower wheel need to be
cleaned in order to maintain efficient operation of the unit. The indicator light
will stay ON until the function is reactivated by pressing this switch for 3 seconds.
c) The light indicator is used for the Smartvent™* function as well (see below).
Smarvent™*(on some models only):
When an excessively high temperature is detected, the detector takes control
over the blower and ensure that an appropriate ventilation is produced. The
controller is equipped with two detection levels.
Protected mode level 1
: When medium heat is detected, the blower sets
itself to speed 3, the corresponding light indicator
comes ON and the indicator flashes.
Protected mode level 2
: When a greater heat is detected, the blower then
sets itself to Boost mode, the corresponding light
indicator turns ON and the indicator flashes.
The blower will remain ON until the heat is back to normal, it then returns to the speed
previously selected.
NOTE: In a case of range top grease fire (temperature exceeding 90°C), the
protected mode will be deactivated to prevent fire propagation.
*TM in Canada only. US TM pending.
4. Light switch:
The light switch allows three different lighting levels according to your needs.
Use
appliance
light bulbs (120V, 40W, A15 model).
WARNING
The protected mode can start the blower even if the hood is turned OFF.
In protected mode, it is impossible to turn the blower OFF with the push
buttons. If you must stop the blower, do it from the main electrical panel.
1 0
!
HC0001
ELECTRONIC CONTROL
11. OPERATION
Always turn ON your hood before you begin cooking in order to establish an air flow
in the kitchen. Let the blower run for a few minutes to clear the air after you turn off
the range. This will help keep the whole kitchen cleaner and brighter.
Содержание Signature S1 Series
Страница 10: ...SERVICE PARTS HL0015 10 3 1 2 5 4...
