8
6. INSTALL
THE
HOOD
6.1
Run power cable to
installation location.
Position the hood in its
intended location. Using a
pen, mark the position of
the screws (as shown at
right). Remove the hood.
6.2
Install the first four no. 8 x 1/2’’ screws, leaving a 1/8’’ gap (do not install screws nos. 5, 6 , 7, 8
and 9 yet).
6.3
Install the wire clamp and insert the power cable in the hood. Place the hood under the
cabinet, slide it in position and tighten the wire clamp to secure the cable. Make sure the
adapter/damper enters the duct opening. Tighten the first 4 screws completely, then add the
last screws (screws nos. 5, 6, 7, 8 and 9) in the center holes. Make sure the damper flap
opens freely.
Using two no. 6 x 1/2’’ screws provided,
secure the adapter/damper to the back of the
hood. Remove tape from damper flap.
Seal the adapter/damper to the hood using metal foil duct tape.
F
OR
V
ERTICAL
D
ISCHARGE
O
NLY
:
Using two no. 6 x 1/2” screws provided,
secure the adapter/damper to the top of the
hood. Remove tape from damper flap.
Seal the adapter/damper to the hood using metal foil duct tape.
HO0179
S
CREWS
P
IVOT
5. INSTALL
THE
ADAPTER/DAMPER
(
ALL
MODELS
) (
CONT
'
D
)
HD0554
1
2
5
6
3
4
8
9
7
HO0178
T
OP
B
OTTOM
P
IVOT
