VendNet 3605, Руководство по обслуживанию

Страница: 8 / 24

3 6 0 5
• 3 6 0 6
8
4 2 2 5 1 3 3 R e v C
REMOVING THE PULL-OUT DOOR
If it proves necessary to reduce the machine depth to approximately 31" the pull-out door can be removed as follows:
1.
Remove the (2) stop screws from the top and bottom
slider channel as shown in Fig 5. Top Hinge:
2.
The Pull-Out Door can now be brought out further to
provide better access.
NOTE: Ensure the 2 screws are replaced at the end of
the procedure to prevent the slides being damaged
3.
Remove/disconnect the (8) ‘P’ Clamp and harness connections as shown
in Fig 6.
Feed all the cables down through the square hole in the base panel to
enable the front assembly to be removed.
4.
Remove and retain the (4) screws that connect the Coin mechanism panel
to the 2 upright Tie Bars.
Remove and retain the (2) screws that connect the support gusset to the
front Tie Bar as shown in Fig 7.
Fig 5. Remove the 2 Stop Screws
Fig 6. Disconnect/remove harness/wires
Fig 7. Remove & retain these (6) Screws