VendNet 3605, Руководство по обслуживанию

Страница: 17 / 24

3 6 0 5
• 3 6 0 6
17
4 2 2 5 1 3 3 R e v C
BILL VALIDATOR OPERATION (OPTIONAL)
To remove the bills from the Bill
Validator push the tab on the top of
the bill box and lift up. To clear jams
or cleaning unlatch lower unit as
shown. Dollar Bill Validator cleaning
instructions as well as more
advanced service information can be
obtained on the Service portion of
the website listed at the end of this
manual.
IVEND™ OPTICAL SENSING
All selections have been assigned at the factory to be monitored for iVend™ optical sensing. At the start of a vend, the iVend™
optical sensor will be checked to make sure it is not blocked, damaged or disconnected.
If iVend is blocked, damaged or disconnected the system can be configured to react in one of 2 programmable ways i) to operate
with a single turn of the vend motor and credit will be taken regardless or ii) the machine will be rendered out of service.
When iVend is operating normally the vend motor and a vend timeout timer are started, the selection motor/s rotate/s a full turn
(360˚) to the home-switch position, if a product is detected dropping into the delivery bin the vend is considered successful.
However, if the home-switch position is reached and a product has not been detected, then the vend motor will pause for 1 second
while the controller continues to monitor the optical sensor for product delivery and then If a product is detected during this pause
the vend is considered successful. If a product is not detected, then the controller initiates a second motor cycle while continuing
to monitor the optical sensor.
If a product is detected during this second cycle, the motor will be stopped immediately. The vend is considered successful. The
2ND
VEND accounting counter is increased by one.
If after reaching the home-switch position and a product has not been detected, then the vend motor is stopped and for 2 seconds
the controller continues to monitor the optical sensor for product delivery. If a product is detected, the vend is considered
successful. The 2ND
VEND accounting counter is increased by one.
If no product is detected, the selection is logged as ‘sold out’. Such a state will trigger to display
the
MAKE ANOTHER SELECTION
message. The original credit remains and is displayed, the customer can press selection buttons to
activate this or another motor or press the coin return button.
DISPLAY CREDIT - ELECTRONIC PRICING
This vendor is equipped with Electronic Pricing, the customer may verify the price by pressing the selection number before inserting
money. If a selection is made and credit has not been established, the price for that selection is displayed and the customer is
prompted “INSERT MONEY”. When money or credit is accepted, then the amount of credit is displayed/confirmed.
"USE EXACT CHANGE ONLY" MESSAGE OPERATION
If the coin levels in the coin mechanism tubes are below the low-level sensors, “USE EXACT CHANGE ONLY” will be displayed. This
indicates the Coin Changer does not have enough coins in the coin change tubes to make/return change. This also indicates that
the Dollar Bill Validator may be disabled until change can be made.