VendNet 3532M, Руководство по обслуживанию

Страница: 14 / 38

COMBI VENDOR • 3532
| 12
Buttons
0-9 are used to move
between the various modes, menus and
sub-menus; while the button is used
to enter a menu, confirm or save a
setting. See Figure 3
DISPLAY
Check the display after pressing the
Service Mode Button
and/or
Keypad
Buttons
to make sure that the
program is responding correctly.
BASIC PROGRAMMING SETUP
KEYPAD
Use the buttons on the keypad as directed in the step-by-step instructions in this manual in
programming the vendor.
1 TUBE
FILL
/ DISPENSE COINS
Tube Fill counts
coins as they are
deposited and
Shows the dollar
amount.
Tube Dispense
Pays out coins
from the coin mech
coin tubes.
This mode will also
display the current
quantity of coins in
the coin mech
tubes.
TUBE FILL
STEP
DISPLAY
1. Press Service Mode Button Motor Count 60
2. Press
and begin depositing coins
At least 15 of each
denomination
3.
Press 2 times to exit
(Sales Mode)
TUBE DISPENSE
1. Press
to dispense dollar coin
$1.00/coins
2. Press
to dispense quarters
0.25/coins
3. Press
to dispense dimes
0.10/coins
4. Press
to dispense nickels
0.05/coins
5.
Press 2 times to exit
(Sales Mode)
**
Note
: For dispensing more than a 4 denomination coin mech. use keys greater in the
same sequence as shown above.**
2 MOTOR COUNT
Displays the
total count of
working
motors.
STEP
DISPLAY
1. Press Service Mode Button Motors ( - - )
2. Press
then wait.
Motors ( - - )
3.
Press to exit.
(Sales Mode)
Figure 3: Keypad