Vemer Dafne, Руководство пользователя

Страница: 44 / 52

English
- 42 -
Dafne chronothermostat, user’s manual
BATTERY REPLACEMENT
The model Dafne (batteries) signals the status of depleted batteries through the symbol
on (field (10) ) and making the display to flash. In this status the regulation is
always guaranteed, but it’s advisable to replace the batteries as soon as possible! (*)
If the charge level of batteries further decreases, the chronothermostat enters into less
consumption mode, it switches off the display and it doesn’t perform any regulation.
(*) Remove the depleted batteries and replace them with the new ones in a maximum
time of one minute (charge reserve) to avoid to lose the settings of date and time
(the performed programmings on the contrary remain memorized even if this limit is
surpassed).
Attention: after batteries replacement, the display will switch on within 15
seconds at max.
 IIn case of replacement, dispose of the used
batteries observing the laws in force in relation
to the disposal of hazardous waste .
The removal of the device takes place by
pulling on the frame convexity
(see figure).
DEVICE RESET
If you want to erase all performed settings and to recharge the default values, proceed
as follows:
1. to switch off and to switch on the power of the chronothermostat (230 V versions)
or to extract the chronothermostat from the wall-mounted base and reinsert it
(batteries versions)
2. during the flashing of the backlighting press the key until the display shows the
writing
dEF
.
Default values are indicated on page 44 of this manual.