14
Transmitters Setup
The calibration data may be entered for up to twelve telemetry transmitters for use in the
Decode
mode (see
Decode
section). The VR60 receiver is shipped with the calibration data setup for any
transmitters ordered with the receiver. Calibration data for other transmitters may be entered from
the keypad, or with the appropriate software (see
Available Software
section). If calibration data is
to be changed or added, select NO when the prompt shown below appears on the display. If the
data does not require alteration then select YES.
TRANSMITTERS
SETUP OK (Y/N)
The transmitter calibration data is stored in memory so it needs to be entered only once for a
particular transmitter. The setup of data is explained below in step form.
STEP 1:
Select transmitter #
At the prompt “TRANSMITTERS SETUP OK (Y/N)”, select NO. The display will then
show:
SETUP TR#?
(0 TO QUIT)
Enter a transmitter number on the keypad between 1 and 12, followed by ENTER. The
display will then show:
TR n XX.X kHz
FREQ OK (Y/N)
where
n
represents the transmitter number just entered and
XX.X
represents the frequency.
STEP 2:
Select Frequency
If the frequency shown is correct, select YES on the keypad. To change the frequency,
select NO and input the new frequency.
STEP 3:
Select decoding type
Press NEXT until the desired decoding type appears. Choose the appropriate type by
selecting ENTER. The existing decoding types are: Interval, Two Channel CAI
(Communication Associates Incorporated), Two Channel Interval, and Rep Rate.
