1 sec
10 sec
max 3 sec
5
1
2
3
a
b
4
a
b
6
VELUX
®
11
ENGLISH
V
A
S 4
5
4
3
6
0
-2
01
9
-0
2
1
Remove dome/top unit.
Setup of wall switch KLI 313 to operate
VELUX INTEGRA
®
solar awning blind MSG
If a non-functional wall switch must be replaced or if the wall switch cannot find certain products, the products can be
prepared for registration by resetting them manually.
Note:
Reset products cannot be operated until they have been registered in the wall switch again.
Important:
This only applies to KLI 313.
6
Replace dome/top unit.
The awning blind can now be operated with the wall switch.
Note:
The motor must be adjusted to the size of the window
before full operation of the awning blind begins. The adjust-
ment will take place automatically the first time the awning
blind is operated. Before the awning blind runs to the preferred
position, it opens and closes. Do not interrupt the adjustment!
2
Open compartment on the solar
awning blind.
3
Press and hold button. The awning
blind runs back and forth 3 times.
Note:
Registration (
4
and
5
) must
now be completed within the next
10 minutes.
4
Press PAIR button on the wall
switch for 1 second.
5
Press the STOP key and then the
DOWN key within 3 seconds.
