P
1 sec
1
2
3
4
6
max 3 sec
5
VELUX
®
10
ENGLISH
V
A
S 4
5
4
3
6
0
-2
01
9
-0
2
If a non-functional wall switch must be replaced or if the wall switch cannot find certain products, the products can be
prepared for registration by resetting them manually.
Note:
Reset products cannot be operated until they have been registered in the wall switch again.
Important:
This only applies to KLI 313.
1
Remove plastic cover.
6
Replace plastic cover.
The roller shutter can now be operated with the wall switch.
Note:
The motor must be adjusted to the size of the window before full op-
eration of the roller shutter begins. The adjustment will take place automati-
cally the first time the roller shutter is operated. Before the roller shutter
runs to the preferred position, it runs all the way up and down.
Do not interrupt the adjustment!
Setup of wall switch KLI 313 to operate
VELUX INTEGRA
®
solar roller shutter SSL or SST
2
Set switch to position
I
.
3
Press button
P
briefly.
Note:
Registration (
4
and
5
) must
now be completed within the next
10 minutes.
4
Press PAIR button on the wall
switch for 1 second.
5
Press the STOP key and then the
DOWN key within 3 seconds.
