Velopex AquaCare Twin, Инструкция по установке, эксплуатации и обслуживанию, Страница: 20 / 44

20
AquaSol.
PROPHY PREP
Removing The Dosing Chamber Lids
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
AquaCare Twin: Installation
A. Ensure the unit is turned off and is fully depressurised. If the machine has been ON
recently, allow 30 seconds for depressurising before attempting to remove the lid.
B. Unscrew the required dosing chamber lid anti-clockwise 2/3 of a turn to relieve the
pressure. Then unscrew a further turn and lift off.
C. Select the required powder, i.e. Prophy or Prep, and shake the required Powder
Cartridge for 10 to 20 seconds (See TREATMENTS, Pg 26-30).
D. Pull out top yellow insert from the cartridge.
E. Pull out the yellow lower draw tab on the cartridge.
F. Line up the rib on the outside of the powder cartridge with the slot on the inside of
the required dosing chamber - Prophy (Left) or Prep (Right).
G. Slide the powder cartridge down into the dosing chamber until it sits comfortably
inside. If the cartridge sits unevenly or above the top of the dosing chamber, then lift
it out and re-insert. Check that the rib of the powder cartridge slides down the slot
in the dosing chamber - refit the dosing chamber lid.
H. Close the dosing chamber by turning lid clockwise. Turn firmly until a strong
resistance is felt from the seal engaging with the top of the chamber. Continue to
turn the lid until you feel the lid tighten against a stop.
Always make sure the lid is
fully closed before pressurising the machine.
I. To remove a powder cartridge, open the dosing chamber lid and gently lift the
cartridge out of the machine. If the cartridge still contains some powder and will be
used again, place the cartridge carefully into the powder storage pot supplied.
All powder cartridges supplied by Velopex are gamma irradiated. The contents are
sterile until opened. Powder cartridges must not be refilled as the cartridges are
not reusable.
AquaSol.