The left remote button controls CH1 relay, the right remote button controls CH2 relay. Each
relay is equipped with a status LED. In ‘0.5s timer’-mode, a relay will remain on for as long as
the remote button is held.
If a timer has been set for a particular channel, the relay will turn on when the button is
pushed. When the preset time has elapsed, the relay will turn off. A timer can be turned off at
any time by pressing the transmitter button again. As long as the timer is running, the cor-
responding led will flash.
In ‘ON-OFF’-mode, the relay will toggle between ON and OFF every time a button is pushed.
IMPORTANT: This unit has an internal heating resistor, this benefits the receiver rage in cold
environments.
To minimize the idle current, remove the heating jumper (example for battery use).
To remove all learned remotes from memory:
turn off the power (disconnect power supply)
hold ‘setup’ button
turn on power (connect power supply)
‘MODE’ and ’CONFIRM’ start flashing
release ‘setup’ after the LED’s turn off
This process takes about 10 seconds.
If the button is released before the LED’s turn off, the memory will not be cleared.
The unit will now respond to the default code only. Please also reset the transmitter to the
default code.
Posted - Tue, Sep 17, 2019 1:48 PM.
Article Number: 1183 | Last Updated: Tue, Sep 17, 2019 3:06 PM
Online URL:
