The relay switch can be set to different modes, from a simple on/of switch to a short or long
timer.
Configuration of channel 1 ‘CH1’ and channel 2 ‘CH2’
tip: to open the enclosure, loosen the two screws on the side.
( Factory defaults: CH1: 1h timer, CH2: 0.5s pulse)
1. Connect the power supply to the receiver unit (see page 2).
2. Push ‘setup’-button repeatedly to select CH1 (left) or CH2 (right) output relay.
3. Confirm with a long push (‘CONFIRM’ flashes 3 times). The selected relay will remain
ON.
1. Push ‘setup’-button a number of times, depending on the desired mode (see table). At
each press, ‘MODE’ will flash a number of times, indicating the current mode
2. Confirm with a long push (‘CONFIRM’ flashes 3 times).
The selected channel will turn off and the unit is ready for use.
If necessary, repeat steps 2 to 5 for the remaining channel.
The unit returns to normal operation when left idle for 10s.
Flashes
Mode
1
ON/OFF
2
0.5 s pulse
3
5 s timer
4
30 s timer
5
1 min timer
6
5 min timer
7
15 min timer
8
30 min timer
9
1 hour timer
Use:
NOTE: Operate the transmitter during at least 2 seconds.
Use button 3 to operate the LED light.
