Velleman NVR1, Быстрое руководство по установке, Страница: 4 / 54

NVR1
V. 01 – 23/03/2012 4 ©Velleman nv
• high compatibility and offsite backup:
o
compatible with all major IP cameras that are ONVIF certified
o
added NAS function to back up all kind of IP cameras on the internet
o
works with free Central Management System (CMS) software for offsite backup
• local and remote control completely independent
• HDMI video output resolution up to 1080P
• optional hard disk: HD500GB/S, HD1TB/S
• USB mouse: GE31010826101, GE31011039100, GE31030414100
• compatible with: CAMIP9, CAMIP11, CAMIP12, CAMIP13
• optional router: EM4542, EM4553, EM4570, PCRT1.
5. Overview
Refer to the illustrations on page 2 of this manual.
Front panel
1
POWER
LED indicator: the NVR is switched on
2
ALARM
LED indicator: an alarm event occurs
3
WAN
LED indicator: the NVR is connected to internet
4
LAN
LED indicator: the NVR is connected to the LAN
5 RECORD LED indicator: recording is on
6
USB port
Insert a compatible USB flash drive for video backup.
Note: For the list of compatible USB flash drives, refer to the full manual on the
CD-ROM.
7 HDD1/HDD2 LED indicator: up to two hard disks are installed in the NVR and connected well
8
mouse port
Insert a compatible mouse.
Back panel
9 AUDIO OUT Connect to an amplifier audio line-in.
10 WAN Connect to internet via an 8P8C (RJ45) network cable
11
HDMI video output
port
Connect to a monitor that supports high-definition video output (HDMI port).
Note: Use an appropriate adapter (not incl.) to connect a monitor with VGA or
composite connectors.
12 LAN Connect to local IP cameras via an 8P8C (RJ45) network cable.
13 DC 19V IN Connect to the power supply adapter (incl.).
14 power switch Switch the NVR on (—) or off (O).
6. Installing the Hard Disk Drive (HDD)
1. Obtain a suitable HDD (not incl.), type SATA (Serial Advanced Technology Attachment). The HDD must be
formatted.
2. Make sure to unplug the device from the mains before servicing and do not touch any electronic circuitry
to avoid electrostatic discharge.
3. Loosen the screws and remove the top cover.
4. Find the hark disk bracket in the NVR, and place the compatible hark disk in the bracket.
5. With the PCB side facing up, connect the hard disk to the power connector and the data connector.
6. Fasten the hard disk with the supplied screws, two for each side.