HAA86C_v3
VELLEMAN
3
4. Command Mode
00
Card-+-PIN-Code Mode
*#
Delete All Access Codes
01
Card-Only Mode
51
Set Alarm Output Time (1 ~ 254s)
02
Card-Only or Key-Press Mode
52
Set Door Delay Close Time (1 ~ 255s)
03
Free-Access Mode
54
Enable Beeper (ON)
04
Alarm Armed (ON)
55
Disable Beeper (OFF)
05
Alarm Disarmed (OFF)
6
Set Door Open Time (1 ~ 254s)
1
Add Single Access Card
71
Modify Password
2
Delete Single Access Card
72
Set Common PIN Code
3
Add a Group of Cards
9
Exit
4
Delete a Group of Cards
Remark : the codes in the command mode should be preceded and followed by a # e.g. #00#, #01#, etc.
5. Operation
Press **123456 to activate the command mode. The initial numeric code (factory setting) is 123456. All examples in
this manual use 123456 as their numeric code. Enter #71# if you wish to change the numeric code. Note that the
operation of the keys is audible.
Remarks
:
•
Enter **123456 (or ** followed by your own numeric code) to enter the command mode. You will hear three beeps
in rapid succession and the LED will momentarily come on (green). Press #9 to exit the command mode. The two-
colour LED turns green as soon as you have entered the numeric code and remains lit for ± 10 seconds. You will
have to start the procedure again if you wait longer than 60 seconds before typing in the next command. Enter # *
# and start over if the operation is interrupted.
a. Selecting the Door-Opening Mode:
- Card-+-PIN-Code Mode
: # 00 #
- Card-Only Mode
: # 01 #
- Card-Only Mode or Key-Press Mode : # 02 #
- Free-Access Mode
: # 03 #
Each successful operation is announced by the LED (green) and by a short and a long beep. The device will still
beep if the operation fails, but in this case the LED does not come on.
b. Connecting the HAA86C with an Alarm/ Disconnecting it
- Alarm signal output
: # 04 #
- Deactivating the alarm signal
: # 05 #
c. Deleting All Access Codes
# * #
d. Adding Access Card(s)
- Add single card
: Press # 1 and hold the card next to the reader or enter the complete card number (6
digits). Next, you should enter ##9.
Note : you can add just one card/card number, press # and press #9 to exit. You can also add a group of
cards as follows:
