Velleman CTC1000SO, Руководство пользователя

Страница: 7 / 46

CTC1000SO
V. 01 – 12/06/2013 7 ©Velleman nv
Clearing the siren memory (factory reset)

The siren resets and clears all memory contents when the batteries are removed.

Wait for 1 minute and set dip switch 6 to ON position before re-inserting the batteries.
The siren will produce a short confirmation tone.

If dip switch 6 is set to OFF, the siren will lose its connection with the control panel whenever it is
restarted.
Strobe Light

The strobe light will flash to indicate various system statuses and can be programmed by dip switch 2
as shown in switch position table.

It will be turned off either when the programmed siren duration has expired or the panel resets the
system.
Setting the tamper protection alarm

If the siren detects a tamper condition it will activate the siren for the programmed alarm period.

If the tamper condition persists, the siren will sound a series of five beeps either every time the
system is armed or when the tamper is enabled, to indicate a fault.

To set the tamper alarm on the control panel:
o
Enter program mode.
o
Go to /-.
o
Select Program Siren and press OK.
o
Select Siren tamp ON or Siren tamp OFF and press OK.
Setting confirmation sounds

The siren can be programmed to produce additional confirmation beeps to tell you when the systems
is armed and disarmed from outside the premises (one beep for armed or home armed, two beeps
for disarmed).

The set up can be done on the control panel under “/-” menu, then “Program Siren” menu
and select “Confirm On” or “Confirm Off”. On the control panel:
o
Enter program mode.
o
Go to /-.
o
Select Program Siren and press OK.
o
Select Confirm On or Confirm Off and press OK.

You can set whether the siren will sound a confirmation beep when arming or disarming the system.
On the control panel:
o
Enter program mode.
o
Go to /-.
o
Select Program Siren and press OK.
o
Select Confirm On or Confirm Off and press OK.
Setting entry sound or or off
You can set whether the siren sounds a beep when you enter the house. On the control panel:
o
Enter program mode.
o
Go to /-.
o
Select Program Siren and press OK.
o
Select Entry Snd ON or Entry Snd OFF and press OK.
Previous alarm warning
If there has been an alarm while you were away, the bell box will sound and flash for 3 seconds when the
system has been disarmed. This only applies to triggering under Away & Home Arm modes.
Note: as the siren is activated for 3 seconds when you disarm your system, this suggests that an intruder
may or may not still be on your premises.
Types of siren sounds

Panic/burglar: continuous siren

Fire: siren will be on (0.5s) and off (0.5s) three times, then comes with a break of 1.5 second.