CS-5MXP GB
6
iii. Disc 2
This control is identical to Disc 1 and allows you to further identify the target signal being
received.
With Disc 1 set at 5 to reject small iron and silver foil, commence searching. Remember the
CS-5MXP is a motion machine which means that the search head needs to be constantly
sweeping, except when in pin point mode - (see page 8).
You now need to set Disc 2 to ignore ring pulls.
Sweep the head above a ring pull and rotate Disc 2, at the same time depressing the Disc 2
push select button with the thumb of the hand holding the machine. When the ring pull
signal disappears this control is set. Release the push button.
Your CS-5MXP automatically operates in Disc 1 so commence searching (see "Sweeping
Technique" on page 11).
When you receive a signal, this indicates that the target could be a silver hammered coin, ...
Depress the Disc 2 button and hold it in. Sweep the target object again. If you are still
receiving a signal, then it is likely to be any of the metal found above ring pulls ...
Disc 2 gives you greater analytical skills than a single discrimination machine but, even
when Disc 2 does not give a signal, still dig the target to avoid losing silver hammered etc.
Effect of Discriminate Control Position
