CS-5MXP GB
11
The technique of getting the best out of your detector is not learnt overnight. You need to get as
much experience as possible so that you can recognise every kind of signal. Indeed, a good detector
operator can often tell you what is being detected before it is unearthed.
It is essential that the search head is kept close and parallel as in 8. Do not hold the head too high
above the ground, or at an odd angle as in A, C and D as you will be apt to miss finds.
SWEEPING TECHNIQUE
For extremely small object searching, such as coins, rings, nuggets, etc. lower the search coil to
within one inch of the ground. Sweeping the coil from side to side in a straight line in front of you.
Keep the coil at a constant height as you sweep from side to side. Move the coil at the rate of one
foot per second.
The optimum sweep rate must be determined by each operator. The detector should be held
comfortable in the hand, with the coil held as closely to the ground as possible. As the detector is
scanned from side to side in front of the operator, the search coil should be advanced approximately
two-thirds the diameter of the coil. This keeps the operator moving ahead, and it allows some
overlapping of each sweep. This overlapping ensures that nothing will be missed. It is well to note
here that the operator should not rush. This is one of the most common mistakes made by detector
users. If you rush, you will not adequately cover the ground.
CARE OF YOUR DETECTOR
Storage
When not in use your detector should be stored in a dry warm environment. If it is not to be used for
a certain length of time it is advisable to remove the batteries to avoid leakage which could cause
serious damage. The working life of your detector will be shortened by careless use or neglect of the
unit. Think of your detector as a scientific instrument. Your detector is designed to withstand rugged
handling on any terrain, but misuse or lack of due attention will tell in the end. After using your
detector in a hostile environment (salt water, sand, etc.) The exterior parts should be flushed with
clean fresh water, paying attention to the head and stems, then carefully wipe dry.
Search Head Position
