Chapter 1 — Getting Started
13
Windows Hardware Driver Installation
15. If prompted, you will need to perform these additional steps:
(a.) Prompt: “Driver Files Search Result.” Message: “Windows found a driver
that is a closer match for this device than your current driver.” Click Next.
(b.) If the “Digital Signature Not Found” screen appears, click Yes.
16. When the driver installation is complete and the prompt “Completing the
Upgrade Device Driver Wizard” appears, click Finish. Close the screens and
return to Device Manager. Do
not
reboot the computer at this time.
17. Return to Step 7 to load the second HD Pro driver, and do so again for the
third. Do not reboot until the final (third) driver is installed
18. When the three drivers have been installed properly, the Device Manager
screen should look similar to that in Figure 1-2, page 14.
19. Note the exclamation marks on the CineView driver(s) you just installed.
Following Vela system software installation, which starts on page 20, the excla-
mation marks will disappear and the resultant Device Manager screen will look
similar to that in Figure 1-3, page 14.
20. Reboot the computer.
21. The Vela System Software Setup screen (Figure 1-11, page 21) should appear
after the reboot. If it does not, run
setup.exe
from the CD-ROM or Start > Run.
22. Follow the directions found at “Software Installation,” page 20.
Driver Installation Difficulties
If you experience difficulty installing the drivers under Windows 2000 with
Service Pack 4 please try the following steps.
1. From Start > Run, run
gpedit.msc
. This will launch the Group Policy Editor.
2. Go to Local Computer Policy > Computer Configuration > Windows Settings
> Security Settings > Local Policies > Security Options.
3. Change the policy for “Unsigned driver installation behavior” to “Warn but
allow install.”
4. Close the Group Policy Editor and reboot the computer.
5. Install the driver as normal.
