Mini VAG505A/VAG506M/VAG506/V801
12
2.9 Output test.
1. Use the
UP/DOWN
scroll button to select [03-Output Test] from
Function menu
(Figure 2.4), and then press
ENTER
button.
You can press
ENTER
button to test. Press
ESC
button to exit. If this
testing is finished, you can press
ENTER
button to continue testing.
If the function is not supported by the vehicle,
a
“Function not
supported by this ECU!
”
message shows on the screen.
2.10 Basic setting.
Basic Settings mode is very similar to Measuring Blocks. The content of
each display group is the same. The difference between the functions is
that the Control Module may try to perform various calibrations while in
Basic Settings mode.
NOTE: You should refer to the Factory Repair Manual for your
particular car (or some other documented procedure) before
"playing" with the Basic Settings function. Failure to follow the
proper procedures can result in serious damage to the vehicle.
1. Use the
UP/DOWN
scroll button to select [04-Basic Settings] from
Function
menu
(Figure 2.4), and then press ENTER.
When the Group number is entered, press [enter].
