Vega VEGAPULS 62 standpipeversion, Руководство по эксплуатации, Страница: 25 / 76

4
E nter the suitable distance value in m for the empty vessel ( e . g .
distance from the sensor to the vessel bottom ) corresponding to
the percentage value
.
5
S ave settings with [ OK ] and move with [ ESC ] and [-
>
] to the max .
adjustment .
P roceed as follows :
1
S elect with [-
>
] the menu item max . adjustment and con fi rm with
[ OK ] .
2
P repare the percentage value for editing with [ OK ] and set the
cursor to the requested position with [-
>
] .
3
S et the requested percentage value with [
+
] and save with [ OK ] .
T he cursor jumps now to the distance value .
4
E nter the appropriate distance value in m ( corresponding to the
percentage value ) for the full vessel . K eep in mind that the max .
level must lie below the min . distance to the antenna edge .
5
S ave settings with [ OK ]
M in . and max . measured values are saved in the sensor . T he values
are displayed in the menu item "
P
eak values "
.
W hen non - contact level sensors are used , the measurement can be
in fl uenced by the respective process conditions . I n this menu item , the
measurement reliability of the level echo is displayed as d B value . T he
measurement reliability equals signal strength minus noise . T he higher
the value , the more reliable the measurement . W ith a functioning
measurement
,
the values are >
10
d
B .
S etup / M ax . adjustment
D iagnosis / P eak value
D iagnosis / M easurement
reliability
VEGAPULS
62
standpipe version • F oundation F ieldbus
25
6
S et up with the indicating and adjustment module
36510
-
EN
-
120301