Q700
3
Quick Setup
(continued)
12. While speaking into each of the
BP-700 headset mics, select the
corresponding monitor "
MON
"
switch on the MS-700 front
panel. Observe the bar-graph
LED's on the left side of the
MS-700 front panel. The "-2"
LED should illuminate often on
voice peaks, but the "+3" LED
should illuminate only rarely.
13. If necessary, adjust the
microphone gain for the
BP-700 via the screwdriver
adjustment access hole on the
side of the unit closest to the
"D" pushbutton. This is the top
adjustment to the right of the
XLR connector and to the left
of the "D" pushbutton.
14. If applicable, connect the wired
intercom system to the rear
panel of the MS-700. Two
intercom channels can be
accommodated at the same
time. For standard Clear-Com
intercom lines, connect line one
to the IC1/IC2 XLR connector,
and line two to the IC2
connector. For "TW" and RTS
systems, both channels are on
the same connector, which
should be plugged into
"IC1/IC2".
15. Select "Clear-Com" on the rear
panel (Clear-Com – TW/RTS
pushbutton "in") for standard
Clear-Com lines, or "TW/RTS"
for Clear-Com two-wire or RTS
intercom lines (pushbutton
"out").
16. On the MS-700 front panel,
select one or both intercom
channels via the "on"
pushbuttons in the intercom
area on the panel. The
incoming signal can be
monitored by selecting the
appropriate monitor "
MON
"
pushbutton and observing the
bar-graph LED's as described
above.
17. Adjust the intercom input and
output levels for the intercom
lines as necessary with the
front panel "in" and "out"
trimmers. If the "null" control
requires adjustment, see
page 14 “Operational Features.”
18. If applicable, connect balanced
line-level program audio or IFB
audio to the "PROG" XLR
connector on the MS-700 rear
panel. Monitor and adjust level
with the corresponding
controls on the front panel of
the unit.
Tx mic gain
adjustment
Rx squelch
sensitivity
