Q700
11
Programming the Beltpack Operating Mode
(continued)
• "B", "C" and "D" are programmed
in same manner. All four LED's
will indicate their current mode
by being on continuously, fast
flashing or slow flashing as
programmed.
• Simultaneously push and hold "B"
and "C" for more than two seconds
to exit the button action
programming.
• If no button is pushed for 10
seconds, the LED's will flash three
times once again.
• This is repeated every 10 seconds
until a button is pushed or 60
seconds has elapsed.
• If no button is pushed within 60
seconds, the beltpack will exit the
programming mode.
Simultaneously push "C" and "D" for
more than 7 seconds to restore
defaults. (Level 2)
• The "C" and "D" LED's will flash
alternately for 3 seconds to
indicate restoration of the preset
defaults.
• After a pause, all four LED's will
triple flash to indicate return to top
level programming mode. (Level 1)
• If no button is pushed for 10
seconds, the LED's will flash three
times once again.
• This is repeated every 10 seconds
until a button is pushed or 60
seconds has elapsed.
• If no button is pushed within 60
seconds, the beltpack will exit the
programming mode.
Push and hold "A" and "D" for more
than 7 seconds to exit programming
mode. (Back to operational level)
• At the operational level when
beltpacks are first turned on, or
when leaving the programming
mode, the following occurs:
• The LED's do not flash.
• The beltpack will go to the
standby condition.
• All pushbuttons will be in the
inactive or deselected mode.
• There will be no transmission in
the PTT mode.
• There will be no transmission in
the PTM or PTE modes.
• At this point, you must push one of
the beltpack buttons to activate
unit, and to begin normal operation.
