Veeder-Root DIS-51, Инструкция по установке, настройке и эксплуатации

Страница: 6 / 32

2
Introduction General
Keep out of reach of children!
General
The DIS-51 unit allows a tanker driver to connect with the station’s ATG to view
continuous level measurements for up to 32 tanks, ullage for the tanks, as well as
any alarms and warnings.
The DIS-51 display is mounted to the inside window of the station. It is operated
by the tanker driver using a push-button switch mounted outside the station in view
of the display. Pressing the button activates the display. Pushing the button
repeatedly displays tank status for each tank. The display clears when the button
has not been pressed for a long period of time.
WARNING
The equipment is used in location where lethal voltages and
explosive vapors or flammable fuels may be present.
FAILURE TO COMPLY WITH THE FOLLOWING WARNINGS
AND SAFETY PRECAUTIONS COULD CAUSE DAMAGE TO
PROPERTY, ENVIRONMENT, RESULTING IN SERIOUS
INJURY OR DEATH.
For this system:
1. Installers and operators must comply with all
applicable safety regulations. This also applies to any
local safety any accident prevention regulations which
are not stated in this manual. In addition, take
necessary precautions during installation, service, and
repair to prevent personal injury, property loss and
equipment damage.
This device must be installed into an electrical system
complying with the plant engineering regulations in
force and equipped at least wih a 2-pole, 6A, C curve,
MCB differential for supply line.
2. The installation of the DIS-51 including wiring to the
TLS console may be only carried out by expert
personnel. Refer servicing to trained and qualified
personnel only.
3. Do not change or modify the display or all any
equipment without the prior consent of Veeder-Root.
4. Substitution of components may impair intrinsic safety.
5. Be sure AC power is “Off” before opening the TLS cover
to access communication jumpers. Do not short any
voltage across any barrier terminal.