22
DIS-51 Configuration Screens
Entering and Changing the Security Code in DIS-51
2.
Short press the push-button switch until you are at “
enable code
,” then long
press to select it.
3.
Short press the push-button switch until you are at “
change code
,” then long
press to select it.
Note the code is the third line on the screen. You can enter a maximum
of 6 characters and this code must match the code on your console.
4.
Short press the push-button switch until you are the first character that needs
to change, then long press to enter into the list of available replacement
characters.
5.
Scroll down and short press the
char
for the first character.
6.
Short press the push-button switch until you are at “
return
,” then long press to
select it.
7.
Repeat steps 4, 5 and 6 for each of the other characters you want to change.
8.
After inserting the entire code, press on “
return
” until you exit the
Configuration menu.
Содержание DIS-51
