S-19-01-1125-UV101 V1.3
7
6. INSTALLATION OF THE UNIT
6.1 Initial set-up
NOTE: Upon receiving the LED Curing Light, check the packaging and parts for any possible damage
that may have occurred in transit. If damage is apparent, please contact your authorized Vector R & D
distributor from which the light was purchased.
1.
Remove the contents from the shipping package. Be careful not to drop or impact the curing light.
Choose a flat, level, sturdy surface to place the charging base on. The light is shipped in a “sleep”
mode, and no timer display. To wake the unit, press the On/Off button.
2.
Before using for the first time, the light must be fully charged. For the first charge, this process will
take about 6 hours. Use only the power supply furnished with the light system. Attempting to use
another power supply source may cause injury or damage and will void the warranty.
3.
Mode button surrounding (charging indicator) illuminates white light during recharging. It will turn
off automatically after battery is fully charged.
NOTE: On/off button surrounding (power indicator) illuminates white light, indicates the handpiece is
well connected to power supply. If no white light comes out when connecting power plug to handpeice
directly or placing handpiece back to charging base, please check the outlet plug is firmly connected or
not.
4.
Autoclave the fiber optic light guide prior to first use. Attach the light guide to the hand piece as
shown in Figure 3. Please refer to Chapter 7 to get more information of optional light guides.
Figure 3 Insert light guide
Disconnect light guide
