IMPORTANT SAFETY INSTRUCTIONS
WARNINGS
1. RISK OF EXPLOSIVE GAS MIXTURES – WORKING IN VICINITY OF A LEAD-ACID BATTERY IS
DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPER-
ATION. FOR THIS REASON, IT IS OF UTMOST IMPORTANCE THAT EACH TIME BEFORE USING
YOUR CHARGER, YOU READ THIS MANUAL AND FOLLOW THE INSTRUCTIONS EXACTLY.
2. To reduce risk of battery explosion, follow these instructions and those published by the
battery manufacturer and manufacturer of any equipment you intend to use in the vicinity of
the battery. Review cautionary markings on these products and on engine.
3. This equipment employs parts (switches, relays, etc.) that produce arcs or sparks. There-
fore, if used in a garage or enclosed area, the unit MUST be placed not less than 18 inches
above the floor.
Battery Safety
1. Use of an attachment not recommended or sold by the battery charger manufacturer may
result in a risk of fire, electric shock or injury to persons.
2. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when discon-
necting charger.
3. An extension cord should not be used unless absolutely necessary. Use of an improper exten-
sion cord could result in a risk of fire and electric shock and will void the warranty.
If an extension cord must be used, make sure that:
a. pins on plug of extension cord are the same number, size and shape as those of plug on
charger;
b. extension cord is properly wired and in good electrical condition; and
c. wire size is AWG#16 (16 gauge) for 100 feet and AWG#14 for distances over 100 feet.
4. Do not operate charger with damaged cord or plug – take to a qualified technician for replace-
ment of the plug or cord immediately.
5. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged
in any way; take it to a qualified service technician.
6. Do not disassemble charger; take it to a qualified service technician when service or repair is
required. Incorrect re-assembly may result in a risk of electric shock or fire, and will void the
warranty.
7. To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance
or cleaning. Turning off controls without unplugging will not reduce this risk.
8. Do not expose charger to rain, snow or use when wet.
Personal Safety
1. Another person should be within range of your voice or close enough to come to your aid when
you work near a lead-acid battery.
2. Fresh water and soap should be nearby in case battery acid contacts skin, clothing or eyes.
3. Wear complete eye protection and clothing protection. Avoid touching eyes while working with
a battery. Acid, acid particles or corrosion may get into eyes. Immediately flood eye with cold
water (eye wash station) for at least 15 minutes and seek medical attention immediately.
4. If battery acid contacts skin or clothing, wash immediately with soap and water. If redness,
pain or irritation occurs, seek immediate medical attention.
5. NEVER smoke or allow a spark or flame in vicinity of battery or engine.
6. Be extra cautious to reduce the risk of dropping a metal tool onto battery. This might cause
sparks or short-circuit the battery or other electrical port, which can cause an explosion.
7. Remove personal metal items such as rings, bracelets, necklaces and watches when working
with a lead-acid battery. A lead-acid battery can produce a short-circuit current high enough to
cause a severe burn.
8. Use charger for charging a LEAD-ACID battery only. It is not intended to supply power to a
low-voltage electrical system other than in a starter-motor application. Do not use the battery
charger for charging dry-cell batteries that are commonly used with home appliances. These
batteries may burst and cause injury to persons and damage property.
9. NEVER ATTEMPT TO CHARGE A FROZEN BATTERY.
Power Cord Safety
This appliance has a polarized plug (one blade is wider than the other) as a safety feature. This
plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse
the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety
feature.
– 2 –
