VECTECH SD-150, Руководство по эксплуатации

Страница: 10 / 28

Cool down:
Without pressing the "＊" key, press the "▼" key directly,
The set temperature drops by 1℃, and the display window shows
Display the set temperature, after releasing the "▼" key,
The display window delays the display of the set temperature for about 2 seconds,
If you press the "▼" key again within the delay of 2 seconds, then
The set temperature drops by 1℃; if you press "▼"
Hold for at least one second, then set the temperature quickly
Decrease until the desired set temperature is released
"▼" key.
parameter
The soldering iron uses the following parameters, which can be adjusted.
Set password
The original password of the main unit's memory is: "000", in this state, the temperature setting is allowed,
If the temperature adjustment is restricted, the password must be changed.
Enter password modification method
1. Turn off the power switch and press "▲" at the same time
And "▼", and then press the power switch.
2. Press and hold the "▲" and "▼" keys,
Until it shows
.
3. When the window shows
The station enters the parameter setting mode.
,weld