VECTECH SD-101, Руководство по эксплуатации

Страница: 9 / 12

cooling down to the room temperature.
1 If the values of „a‟ and „b‟ are different from the values in the following table, replace the
heating element or sensor or cord assembly. Refer to the following steps.
the process into the temperature setting.
2. temperature setting
temperature up: Don‟t press “*” key, and press “△” key directly. And the “Set Temp” will raise
1
℃
and the display will show the setting temperature. If pressing the
“△”
key about one second, the setting temperature will rise rapidly. And then loose
the “△” key till the needed temperature.
Temperature down : press
“▽”
key directly. And the “Set Temp” temperature will drop1
℃
and
the display will show the setting temperature. If pressing the “▽” key about
one second, the setting temperature will drop rapidly. And then loose the
“▽” key till the needed temperature.
3.3.3 Mode setting
When inputting the correct password and the display shows , press “ △ ” and “ * ” keys
simultaneously to the mode setting. The display shows the current setting value and change the
type of the modes by pressing “△” and “▽” keys. The changing series as following:
Working mode tabl e
3.3.4 Other setting
1 press the “△” or “▽” key can change the setting value.
2 sleep time setting
The station has an auto-sleep function. When not operating the station during a certain
period of time (the setting sleep time), the power supply will be cut off and the station will
come into the sleep state.
1) Select the needing mode and then press “*” key to the process of “sleep time” setting. The
display shows and then press “△” or “▽” key to change the sleeping time. The range
of sleeping time is from 0 minute to 250 minutes.
2) After finishing setting the sleeping time, press “*” key to the process of off time setting.
3) To resume soldering, there are several ways as follows:
* Turn the power switch off and then turn on.
* Press “*”.
*
Take
up the
iron-
handl
e.
Note:
*
Working
mode
Temperature range Handle type Tip type Remark
0 80 ℃ ~480 ℃ Electromagnet Normal tip
is a
alarming
mark.
1 80 ℃ ~480 ℃ Electromagnet Big tip
0 80 ℃ ~480 ℃ Electromagnet Normal tip
1 80 ℃ ~480 ℃ Electromagnet Big tip
1
0
0
1
Press △
Press ▽ Press ▽
Press △ Press △
Press ▽
Select working mode
Press* key
Setting temperature
Press * key
Press * key
Press * key
Press*
key
Page7 Page14
Press power key