Page 2
"WHHR100/90DC-B PLUs" - WHOLE HOUsE HEAT RECOVERY UNIT
INsTALLATION AND OPERATINg INsTRUCTIONs
safety Notice
It is important to read this Instruction Manual carefully before installing or using the product. Following
these instructions will ensure that your ventilation system is installed, commissioned and used properly and
continues to operate effectively. Vectaire will not be held responsible and will not accept liability for any
damage caused to persons or property through failure to follow the guidance provided in this manual. It
should always be available with the product for easy reference.
Your unit sHOULD NOT be switched off. It is designed to run continuously. If it is switched off indoor
pollutant and moisture levels may increase.
WHHR100/90DC-B Plus:
5"/125mm spigot, for dwellings up to 200m
2
, max capacity 80 l/sec
general Information
The Vectaire WHHR100/90DC-B Plus heat recovery system pro-
vides whole house mechanical ventilation to living areas, bedrooms,
kitchen and bathrooms. It extracts stale, contaminated air from
kitchens, utility rooms and bathrooms, and uses the heat recovered
from this air to warm fresh, incoming air to create a flow of fresh air
throughout the dwelling. The extract and intake air streams are sep-
arated to avoid contamination.
Heat is reclaimed from extracted air and used, via the heat exchange
process, to warm incoming fresh air. The system will operate contin-
uously to create a stable, comfortable, healthy environment avoiding
the use of excessive energy and saving heat already generated.
The heat recovery unit will generally be installed in the loft of a house
or the void above the ceiling in an apartment (but may be installed in
a cupboard) and will be connected by hidden ductwork to vents sited
in the ceilings of the rooms which require ventilation. Each unit is
commissioned individually allowing its performance to be tailored to
suit the performance required. There will be a facility to boost the
extraction rate when desired (e.g when cooking or bathing or pollutant levels rise). This may be done automati-
cally or manually.
The system is designed to run continuously and should NOT be switched off except for maintenance or filter
replacement.
Features
•
sAP Q Eligible
whole house heat recovery unit giving continuous ventilation in the kitchen and up to four
additional wet rooms (using rigid ducting)
•
low noise levels
•
variable choice low (trickle) speed and boost options for optimum setting at installation
•
boost speed can be triggered by a switched live connection from a variety of external devices including:
-
PIRFF (passive infra red)
*
-
DRH240 (dynamic remote humidistat)
*
-
THM (thermostat)
*
-
a light switch (if more than one light switch is used,
each one must be a double pole switch)
- a remote switch/pull cord
(
*
PIRFF, DRH240 and THM may have integral over-run timer which controls the length of time that the fan
will continue to operate at its boost speed after the boost has been switched off.)
•
Installation MUST be carried out by suitably qualified personnel and MUST be in accordance with current IEE
regulations and all appropriate standards and applicable regulatory guidance.
