95
GETTING TO KNOW YOUR SPC-3000/3500
2.5 Main Board Jumper Settings
2.5.1 Front View of SPC-3000 Main Board With Jumper Location
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To “close” a jumper, you connect the pins
with the clip. To “open” a jumper, you remove the clip. Sometimes a jumper will
have three pins, labeled 1, 2, and 3. In this case you would connect either pins
1 and 2, or 2 and 3.
The figure below is the top view of the SPC-3000 main board. It shows the
location of the jumpers.
2
1
2
10
1
9
JP5
JP9
JP4
JP10
JP2
GIOP DC Electrical Characteristics:
Содержание SPC-3000
Страница 106: ...99 HARDWARE INSTALLATION Step 3 Remove two F M3x4 screws Step 4 Take off the bottom side...
Страница 110: ...103 HARDWARE INSTALLATION Step 3 Fasten the washer 3 5 Installing SIM Card Step 1 Open the SIM card cover...
Страница 112: ...105 HARDWARE INSTALLATION Step 3 Install SATA cable with SSD HDD Step 4 Close the bottom side...