32
©Vecow ABP-3000 User Manual
GETTING TO KNOW YOUR ABP-3000
2.6.2 Ignition Control Wiring
To activate ignition control, you need to provide IGN signal via the 3-pin
pluggable terminal block locates in the back panel. It is below the general wiring
configuration.
For testing purposes, you can refer to the picture below to simulate ignition
signal input controlled by a latching switch.
Note :
1.
DC power source and IGN share the same ground.
2.
ABP-3000 supports 9V to 50V wide range DC power input in ATX/AT mode. In
Ignition mode, the input voltage is fixed to 12V/24V for car battery scenario.
3.
For proper ignition control, the power button setting should be "Power Down"
mode.
In Windows for
example, you need
to set "When I press
the power button" to
Shut down.
Pin No.
Definition
1
Ignition (IGN)
2
SW+
3
SW-
IGN
V+
