Veco S
Installation Manual –Page 10 / 20
SUMMER
: When the unit is in SUMMER mode, the system will run in cool mode as chiller, cooling
the water until a specified set-point temperature value is reached.
WINTER
: When the unit is in HEAT mode, the system will run as heat pump, heating the water
until a specified set-point temperature value is reached.
OFF
: when unit is in OFF mode, the compressor will not run but the unit will be powered up.
When the system is powered up it will recall the previous mode of operation.
When the system starts for the first time, it will start in OFF mode.
3.4.
Climma functions
When the compressor is running, the system can run with two different functions:
AUTO function
: when system is in AUTO function, the Climma Control will automatically adjust the
system power: when more power is requested, the compressor will run up to its maximum speed,
but when less power is requested, compressor will slow down.
ECO function
: when system is in ECO function, the Climma Control will automatically adjust the
system power, but this time the maximum power is limited to a specific ECO value, which allows
you to set a maximum power consumption, lower than the maximum system power
consumption.
Example.
Chiller maximum power consumption: 4,2kW
Generator: 10kW
When you are running the generator you can set the AUTO function on. If the system will run at full
power, it will still work with no problems, even at maximum speed.
When you are docked, you cannot run the generation and you have only 4kW from the harbor, then you
can set the ECO function on. This will allow the system to run up to 50% of its overall power, this means
that the power consumption will be limited around 2kW, allowing the system to run anyway.
3.5.
Starting the unit
To start the unit, turn on the main power supply from the dedicated circuit breaker.
The display will show the following screens.
When the display shows the following screen, it’s possible to change the language from Italian to English
or the other way around.
To change the language from the current one, press ENTER. To confirm the current language press ESC.
If nothing is pressed, the system will start with the current language settings.
After the language settings, the system will go to the main screen.
