WARNINGS FOR THE INSTALLER
GENERAL SAFETY OBLIGATIONS
1) ATTENTION! To ensure the safety of people, it
is important that you read all the following
instructions. Incorrect installation or incorrect
use of the product could cause serious harm to
people.
2) Carefully read the instructions before beginning
to install the product.
3) Do not leave packing materials (plastic,
polystyrene, etc.) within reach of children as such
materials are potential sources of danger.
4) Store these instructions for future reference.
5) This product was designed and built strictly for
the use indicated in this documentation. Any other
use, not expressly indicated here, could
compromise the good condition/operation of the
product and/or be a source of danger.
6) Manufacturer declines all liability caused by
improper use or use other than that for which the
automated system was intended.
7) Do not install the equipment in an explosive
atmosphere: the presence of inflammable gas or
fumes is a serious danger to safety.
8) The mechanical parts must conform to the
provisions of Standards EN 12604 and EN 12605.
9) Manufacturer is not responsible for failure to
observe Good Technique in the construction of the
closing elements to be motorised, or for any
deformation that may occur during use.
10) The installation must conform to Standards EN
12453 and EN 12445. For non-EU countries, to
obtain an adequate level of safety, the Standards
mentioned above must be observed, in addition to
national legal regulations.
11) Before attempting any job on the system, cut out
electrical power.
12) The mains power supply of the automated
system must be fitted with an all-pole switch with
contact opening distance of 3mm or greater. Use of
a 6A thermal breaker with all-pole circuit break is
recommended.
13) Make sure that a differential switch with
threshold of 0.03 A is fitted upstream of the system.
14) Make sure that the earthing system is perfectly
constructed, and connect metal parts of the means
of the closure to it.
15) The safety devices (EN 12978 standard)
protect any danger areas against mechanical
movement
r
isks, such as crushing, dragging, and
shearing.
16) Use of at least one indicator-light is
recommended for every system, as well as a
warning sign adequately secured to the frame
structure, in addition to the safety devices.
17) Manufacturer declines all liability as concerns
safety and efficient operation of the automated
system, if system components not produced by
manufacturer are used.
18) For maintenance, strictly use original parts.
19) Do not in any way modify the components of
the automated system.
20) The installer shall supply all information
concerning manual operation of the system in
case of an emergency, and shall hand over to the
user the warnings handbook supplied with the
product.
21) Do not allow children or adults to stay near the
product while it is operating.
22) Keep radiocontrols or other pulse generators
away from children, to prevent the automated
system from being activated involuntarily.
23) The user must not attempt any kind of repair or
direct action whatever and contact qualified
personnel only.
24) Transit is permitted only when the automate
system is idle.
25) Maintenance: check at least every 6 months
the efficiency of the system, particularly the
efficiency of the safety devices (including, where
foreseen, the operator thrust force) and of the
release devices.
26) Anything not expressly specified in these
instructions is not permitted.
