Warning!
When establishing the height off the ground at which to fasten the plate
(A) (FIG.1)
onto
the post, keep in mind the height at which the plate will be fastened for anchoring the piston to the
gate and that the plate
(B)
must be fastened
40 mm
below that on the post to obtain horizontal
levelling.
(FIG.3)
Installing the anchor plate on the piston to the gate
Release procedure
(FIG. 4)
(FIG. 3)
INSTALLATION OF FASTENING PLATES
(FIG. 1)
(FIG. 2)
4
0
m
m
A
B
Fix the back plate to the
pillar.
(FIG. 1)
Anchor the rear part of the piston
to the plate and fasten it firmly
( FIG. 2)
1.
Fit the anchor plate onto the piston
(fig. 4)
2.
Close the gate
3.
Move the piston with the plate already fitted
towards the gate
4.
Move the fitting to limit stop, then move it
back by approximately 1 cm and mark the
position of the plate.
5.
realize the same operation in opening.
6.
If positions correspond, fix the plate on the
gate; otherwise revise
A
and
B
units
(table 1)
Insert the key provided, turn 90° and lift up the lever.
In this position the actuator will be blocked.
Blocked
Unblocked
