04/11
INSTALLATION INSTRUCTIONS: Viewline 52 mm
Freshwater gauge (capacitive)
TU00-0752-9207102
1-5
2
Technische Änderungen vorbehalten - Technical details subject to change
TU00-0752-9207102
GB
1
2
3
4
5
If installing the instrument near a magnetic compass,
note the magnetic safe distance to the compass.
Before beginning, turn off the ignition and remove
the ignition key. If necessary, remove the main circuit
switch.
Disconnect the negative terminal on the battery.
Make sure the battery cannot unintentionally restart.
•
Before beginning, disconnect the negative terminal on the battery, otherwise you risk a short circuit.
If the vehicle is supplied by auxiliary batteries, you must also disconnect the negative terminals
on these batteries! Short circuits can cause fires, battery explosions and damages to other electronic
systems. Please note that when you disconnect the battery, all volatile electronic memories lose their
input values and must be reprogrammed.
0.3 m
Place the new front ring on the instrument and press
it on until it is flush with the instrument glass.
The following rings may be installed as alternatives
to the supplied front ring:
Front ring, flat; black
A2C53186040
Front ring, flat; white
A2C53186022
Front ring, flat; chrome
A2C53186023
Front ring, triangular; black
A2C53186024
Front ring, triangular; white
A2C53186025
Front ring, triangular; chrome
A2C53186026
Front ring, round; black
A2C53186027
Front ring, round; white
A2C53186028
Front ring, round; chrome
A2C53186029
6
7
•
Do not drill holes or ports in load-bearing or stabilizing stays or tie bars!
• Note the necessary clearance behind the drill hole or port at the installation location. Required mounting depth:
65 mm.
• Drill small ports; enlarge and complete them, if necessary, using taper milling tools, saber saws, keyhole saws
or files. Debur edges. Follow the safety instructions of the tool manufacturer.
Conventional assembly. (Instrument is put into the
drill hole from the front).
The panel width may be within a range of 0.5 to 20 mm.
The drill hole must have a diameter of 53 mm.
A:
0.5... 10 mm
B:
0.5... 20 mm
A
B
or
For 52 mm instruments, the fastening nut can be
mounted at position A or B. This allows you to realize
various clamping heights.
Version A
Clamping height 0.5 – 10 mm
Version B
Clamping height 0.5 – 20 mm
Procedures for installing VDO Viewline instruments
0.5... 20 mm
Ø 53 mm