Remote control holder
■
1. Sticking on the holder
☞
Stick the supplied adhesive pad onto
the area provided on the holder, then
stick on the holder, pressing firmly.
✎
The mounting surface must be free of
dust and grease.
✎
The installation temperature should be
at least 15° Celsius so that the adhesive
strip can develop its full adhesive
strength.
■
2. Screwing on the holder
☞
Screw the holder directly to the installa-
tion position using two suitable screws.
Making the electrical
connections
Install all cables with care. For wiring details,
refer to the connection diagram and to the
adjacent table.
Power supply cable
(ISO chamber A), Fig. 2:
A
Only connect electrical signals to suitable
connecting points in the vehicle.
A
If connection is made directly to the
battery, protect the positive lead (red lead)
with a 10 A fuse close to the battery (approx.
10 - 15 cm).
☞
Connect the free wire ends A4, A7 and
A8 of the power supply cable to suitable
connection points in the vehicle in ac-
cordance with the connection diagram
and the table.
✎
Do not cut non-assigned wires. Instead,
wind them together and secure to one
side. They may be required for retrofit-
ting additional functions.
Speedometer signal
(ISO chamber A):
Depending on the type of speedometer signal,
either the digital (A1) or the analogue (A3)
input must be selected. Check speedometer
signal using an oscilloscope if necessary.
Many vehicles are equipped with a speedo-
meter signal on one of the radio connectors.
For further information contact your vehicle
dealer or our hotline.
If your vehicle is not equipped to produce an
appropriate speedometer signal, an optional
speed sensor can be installed. This is available
as an accessory from your installation service.
A
Never collect the speedometer signal
from the ABS control!
28
OPERATION
SETUP
INSTALLATION
CONTENTS
Pin
Cable colour
Connection
A1
Black/white
Speedometer signal input, digital (long cable)
❍
A2
White/yellow
Switch input reversing signal (reversing light positive)
●
A3
Black/white
Speedometer signal input, analogue (short cable)
❍
A4
Red
+ 12 V permanent positive; terminal 30 (where necessary via 10 A cable fuse)
●
A5
White/blue
“Accessory” switch input
❍
A6
Grey
Low beam positive
●
A7
Purple
+12 V ignition positive; terminal 15 (without switch-off on starting engine)
●
A8
Brown
Battery negative; terminal 31
●
●
= Connection required
❍
= Connection optional
