VDO MR6000, Руководство пользователя и инструкции по монтажу

Страница: 35 / 348

35
English
Fuse is blown.
Incorrect wiring.
Microprocessor fault.
Operating panel or unit connec-
tions are dirty.
Display is not extended.
Infrared sensor
l
for LCD
display is exposed to direct
sunlight.
Remote control batteries are
missing or discharged.
Parking brake is not applied.
Brightness is set too low.
Adverse operating conditions.
Headlamps are switched on.
Colour setting is incorrect.
NTSC/PAL setting is incorrect.
7. FAULT FINDINNG
Unit cannot be
switched on
(no tone).
No reaction to button
actuation.
Display incorrect.
Remote control not
functioning.
No picture.
Picture is too dark.
Display colours are
too weak or defec-
tive.
Picture distortion on
connecting video
recorder.
Fault
Replace with a new fuse of the same ampere value. If the fuse
should blow again, please contact a VDO Dayton authorised
dealer.
If the fuse should blow again, please contact a VDO Dayton
authorised dealer.
Switch off the unit and then actuate release button
6
for
removal of the operating panel.
Press the RESET button for approx. 2 seconds using a thin
object (e.g., paper clip).
Wipe the terminal strip clean using a soft cloth moistened with
cleaning alcohol.
The remote control function is only available with the unit
extended.
Operation of the remote control etc. is impaired by the inci-
dence of direct sunlight on the IR sensor.
Check the remote control batteries or plug the remote control
into the holder.
Ensure that the parking brake is applied.
Correct the brightness setting.
Temperature in the vehicle is 0°C or less. Heat interior (to
approx. 25°C) and check again.
The display becomes somewhat dimmer in the dark, i.e. when
the headlamps are switched on, in order to prevent dazzling.
(Therefore, check whether the headlamps are switched on if the
display is too dark.)
Ensure that COL (colour) and HUE are set correctly.
Set the NTSC/PAL switch to video recorder.
Cause Remedy
TV
General
RESET button